[nikomat 36054] Dの操作説明

[SATO Yoshiyuki <sato@cyg.fuji-ric.co.jp>]

丹後屋す

Bronica Dの売り手とメールのやり取りをしていたら、
いつのまにか、SATO San で始まるメールが届くようになり、
（キッカケは、お前の名前のlast nameは一体どっちなんだ
　から始まって、名前表記の順番の話になり、
　それから、日本では呼びかけるときは名前の後にSanをつけるのだ、
　それで、SATO SanもYoshiyuki Sanでもどっちも
　あんまり変らんよ、なんてことを言ってやったら、次からずっと
　SATO San。この人、メールの最後の挨拶はdomo（どうも）。
　
　最初、私のメールアドレスを
　SATO Yoshiyuki<satoysyk@nifty.ne.jp>）と設定しておきながら、
　メールの最後に　Yoshiyuki　Satoと書いたものだから、
　混乱してしまっていたみたい。）

で、物は今ごろ輸送業者の倉庫の中か空の上かというところですが、
ちょっとメールが途絶えたと思っていたら、
次のような操作説明書が届きました。ありがたいことです。

　これからDを求めたい人のために、ご参考まで(^^;

--------------------------------

Bronica Camera Directions:

  To remove back totally push in on dark slide, it is shinny metal
 located behind the strap attachment on the left hand side of the
 camera as you hold it.  If you push hard with the handle out of 
 the way it pops open.


  To remove the detachable film loading part only use the open control
 on the left side of the detachable film back.  Push in on the button
 below it and turn it to open and the back pops loose, you may then
 remove it.  To put it back on just slide it into place and push and
 it pops into position light tight.  

  To change the shutter speed use the dial on the right side as you
 hold the camera, the big one on the body of the camera.   B of course
 leaves the shutter open as long as you have the button pushed down.
 It is for time exposures.  

  To make it work the dark slide must be out of the camera back.
  Also ignore the small groved button like thing on the same side as
 the above, it will if you move it go back to the original position
 when you use the dark slide.  

  To advance the film, pull the large knob that the shutter speed on
 out away from the body and rotate forward.  Watch and the back button
 turns on the same side.  

  Be sure to look at the film in the camera, an old roll outdated not
 good left in for an example.  

  To load the reels use the plastid knobs with arrows in red on one
 part. Push them together and the film is freeded from the holders.
 The other you push out and one side will pop out and then you can
 remove the film or if loading you can allign and secure film then
 release to secure it into position.  

  To release the lens push the chrome odd looking ring on the lens and
 rotate, it comes off.  To mount it put the two red dots together and
 turn clockwise, it snaps into position.  

  To check the f-stops pull the dark slide out and push on the red
 button on the front and watch as the f ?stop or factor number opening
 is revealed.  

  It is a jewel of a camera, a beautiful and functional camera that
 gives you a large 120mm negative.   

--